Magazine Bases
Glock;
This a slip on design and directly replaces the standard base plate
Available for Small (9mm, 357Sig & 40 S&W) or Large (10mm & 45 ACP) frame magazines
**Please note** - You will need to trim the plastic tabs from the either side of your magazine for these bases to fit. This will in no way affect the use of the magazine or even the use of the original plastic bases.
Sig Sauer;
This a slip on design and directly replaces the standard base plate on full metal magazines. Works with either 10 or 15 round mags.
**Please Note** - These bases are not compatible with 10rd magazines with plastic insert bases.
2011 Standard;
These a slip on fit to replace your plastic magazine bases.
** Please Note** - Due to magazine differences you may need to lightly file (round) the front edges the magazine base wings to allow fitting.
2011 Open;
These a slip on fit to replace your plastic magazine bases.
** Please Note** - Due to magazine differences you may need to lightly file (round) the front edges the magazine base wings to allow fitting.
PC9 Parts
Stock Adapter;
This a slip on fit and designed to take all commercial and MilSpec buffer tubes.
Utilises 5/32 allen socket screw to attach to rear Picatinny Rail, this allows for quick removal for storage and transport.
The buffer tube is indexed and held in place by the 2x 3/32 set-srews at the base of the adapter.
Flat Faced Trigger;
This a drop in fit, direct replacement for the plastic OEM part.
The flat face allows for lighter feel due to the design and gives you a repeatable finger position for more accurate firing.
Use the set-screw (lock tight recommend) to reduce the over-travel of your trigger to enhance your accuracy and speed of your follow up shots.
Extend Charging Handle;
This is a direct replacement for the OEM charging which is slightly larger to provide a better grasp to allow for easier maniplulation of the bolt.
**Please Note** - This uses the OEM screw for attachment.
Extended Magazine Release;
This is a direct replacement for the OEM magazine release which is slightly larger to clear the molded guard around the release. This allows for easier maniplulation of the magazine release for faster reloads.
**Please Note** - This uses the OEM screw for attachment.
Scope Level Kit
To use this kit you need a flat surface or rail under your scope;
1. Place your scope loosely in your rings so it can still be rotated.
2. Place the square part (small edge down) on the surface under the scope turret.
3. Insert the wedge into the keyway and side upwards making contact the underside of your scope.
4. Tighten your scope ring screws to your desired torque.
Now your scope is leveled precisely to your rings.
Includes 2 inserts small (5-15mm) and large (14-24mm).
Ranges from 5mm (minimum) to 24mm
